Red Rock Wilderness Store - Ely, MN - BWCA

How to Fillet a Northern Pike
(and most other fish)

Learn proper canoe handling only from Red Rock Wilderness Store

Step One
STEP 1: Make first cut by grasping fish between the gills and poking knife into softer throat region ahead of the two front fins
Step One
STEP 2: Slide knife forward towards tail of fish between the two middle fins and stop by the bottom fin just in front of tail
Step One
(Still) STEP 2: Slide knife forward towards tail of fish between the two middle fins and stop by the bottom fin just in front of tail
Step One

STEP 3: Lay fish on side and make a vertical cut using a sawing motion down to the backbone taking care to NOT slice through the backbone.
Step One
STEP 4: Turn your knife flat and parallel to the backbone. Saw along the backbone (You'll hear rib-bones and "Y" bones being cut through) to the tail, removing the complete slab of fish meat (?) which is one fillet. Do this to each side of fish.
Step One

STEP 4a: Cutting gets easier near the tail becasue you're not cutting through rib bones.
Step One

STEP 5: Remove the belly fin by slicing with the tip of your knife.
Step One

STEP 5a: Removing fin is easy if you hold it up and slice it off

 Step One

STEP 6: Locate the row of rib bones on the fillet by feeling them with your finger. Then, place your knife edge right behind them and slice underneath. Remember to turn your knife blade up against the underside of the ribs immediately as you are making long, steady slices down the row of rib bones. The idea here is to remove the ribs without wasting meat.

 Step One

STEP 6a: After slicing about half to three quarters of the way under the ribs, hold the fillet down with your knife point, grasp the ribs and tear them out. This move greatly speeds up the process and helps if you have a lot of fish to fillet.

Step One

STEP 7: Grasp the tail of the fillet with pliers and cut into flesh with blade while turning blade almost flat and sawing. Simultaneously pull with the pliers and push with the knife with a sawing motion. It helps to waggle your plier hand from side to side as your knife hand saws down the skin of the fillet.
Step One
STEP 7a: Continue down the fillet. The feeling in the knife is one of slight tearing as it cuts. Too sharp of your blade angle and you slice through the hide. Too flat of a blade angle and you will leave meat on the hide. Your knife must be quite sharp and you'll need to develope a feel.
Step One
STEP 7b: If you will be transporting your fillets, turn your blade down and slice sideways leaving a patch of skin on the fillet for identification purposes.
Step One
STEP 8: Completed Northern Pike fillets will look like this if done properly. If they look like they were driven over by a streetsweeper, you'll need a bit more practise.


How to locate the "Y" bones AFTER frying the fillet (Click Here)

Learn proper canoe handling only from Red Rock Wilderness Store


 

Red Rock's Online Catalog



Click here for a road map and directions to our place!

 

Have a question? Call or e-mail us!
218-365-4512 redrock@redrockstore.com

 

HOMEReturn to Home Page


Copyright © 2004, Northwind Outdoor Recreation, Inc. All Rights Reserved.
redrock@redrockstore.com
Last Revised -January 04,2004


Red Rock Wilderness Store
2267 Fernberg Road
P.O. Box 690
Ely MN  55731